Dallas Green Sprinkler Repair provides Sprinkler Repair in Dallas, TX.
Sprinkler repair in Dallas is the diagnosis and replacement of failed irrigation parts, spray and rotor heads, valves, backflow devices, wiring and controllers, that keep a residential lawn watering evenly across Dallas County's clay soil.
Every service reflects the same meticulous attention to detail, whether it's a single job or a larger sprinkler repair project across Dallas.
Cracked, tilted or missing spray heads get swapped and re-aligned so the pattern covers the lawn instead of the sidewalk. A single pop-up spray head runs about $10, $25 in parts; gear-driven rotor heads used on larger Preston Hollow lots cost more. Matters most when a head is throwing a geyser and spiking the water bill.
Get a quote →
A zone that won't open or won't shut off usually traces to a failed solenoid or a torn diaphragm inside the valve. Valve rebuilds and replacements typically run $125, $300 per valve depending on depth and access. This is the fix when one zone stays dry while the rest of the yard runs fine.
Get a quote →
Freeze-cracked backflow assemblies are the classic post-freeze Dallas failure, since exposed brass above ground splits when water inside expands. Rebuild kits or full replacement run roughly $150, $450. Backflow devices protect the drinking-water supply and fall under city cross-connection rules, so a working assembly is required before the system pressurizes.
Get a quote →
When a whole zone is dead, the cause is a solenoid, a buried wire break, or a controller output, tracing it with a meter isolates the fault instead of digging blind. Diagnostic visits typically start at $75, $95. Best choice when multiple heads on the same line all stopped at once.
Get a quote →
A timer with a blank display, a dead battery back-up, or zones that skip their programmed run gets tested and, if needed, replaced with a comparable controller. Basic controller swaps run about $150, $350 installed. The right call when heads and valves check out but nothing runs on schedule.
Get a quote →
Soggy spots, pooling water, and a meter that spins with the system off point to a cracked lateral line or fitting underground. Line repairs run roughly $100, $300 depending on how far the excavation runs. This addresses the hidden waste behind a mysteriously high summer water bill.
Get a quote →
A startup pressurizes the system, checks every zone, adjusts heads knocked out of alignment over winter, and flags any freeze damage before it wastes water. Startup checks run about $75, $150. Peak demand March through May, so booking early avoids the spring backlog.
Get a quote →
Draining and shutting down the system before a hard freeze protects the backflow device and above-ground piping. Winterization visits run roughly $75, $150 and fill up through November. This is the step that prevents the cracked-brass repair the following spring.
Get a quote →You get a firm, itemized quote for your sprinkler repair before any work begins, no surprises, no pressure.
Careful prep, tidy work, and a full cleanup when we are done. We treat your home and belongings like our own.
The same trusted, background-checked team from the first call to the final check.
If one head sprays sideways or gushes, choose a head replacement, it is the cheapest fix, usually $10, $25 in parts plus labor, and takes under an hour. If a whole zone stays dry while others run, choose valve or wiring diagnosis, because the problem is a failed solenoid, diaphragm or a broken low-voltage wire rather than the heads. If the whole system is dead after a hard freeze, choose backflow inspection first, a cracked brass assembly on the [Texas Commission on Environmental Quality](tceq.texas.gov) backflow-testing schedule must be repaired before the system can safely pressurize.
If the controller shows no display or skips programmed times, choose a controller repair or replacement, since the heads and valves may be perfectly fine. The trade-off is straightforward: chasing individual heads is cheap but slow if the real fault is upstream at the valve or timer, so a full system check first often saves money on a lawn with several dry patches.
Every project gets a firm, written price after an on-site visit. Ranges below for orientation.
Tell us about your sprinkler repair job and we'll send a clear, written quote, usually the same day. Or just call and talk to a real Dallas pro.
(469) 326-1277
Dallas sits on expansive Blackland clay soil that swells when it rains and shrinks in a summer drought, and that constant ground movement shears buried lateral lines and shifts heads out of level, a documented behavior the [USDA Natural Resources Conservation Service](nrcs.usda.gov) classifies as high-shrink-swell clay. Older established lots around Lakewood, the M Streets and Casa Linda near White Rock Lake tend to have mature systems with brittle PVC and hand-dug valve boxes, while newer builds in Lake Highlands run modern gear-driven rotors. Watering during a City of Dallas restriction window also concentrates demand, so a stuck-open valve or split head near the Dallas Arboretum or the Trinity River Greenbelt wastes water fast, checking heads under the [EPA WaterSense](epa.gov) guidance keeps a Dallas lawn green without overrunning the meter.
Dallas Green Sprinkler Repair